Delay
Effects
Echoes with feedback.
Delay plays what comes in again after the time you set. Feedback sends part of each echo back in, so it repeats and fades. The low-pass cutoff darkens each repeat, as tape does. Mix sets how much of what you hear is echo.
Settings
- Bypass
Lets the sound through unchanged.
- Values
- On or off
- Default
- Off
A control node can move it.
- Time
How long the sound waits before it echoes.
- Range
- 0 s to 2 s
- Step
- 1 s
- Default
- 0 s
A control node can move it.
- Feedback
How much of each echo goes back in to repeat.
- Range
- -100% to 100%
- Step
- 50%
- Default
- 0%
A control node can move it.
- Mix
How much of what you hear is echo.
- Range
- 0% to 100%
- Step
- 100%
- Default
- 0%
A control node can move it.
- Low-pass cutoff
Above this frequency, each echo rolls off.
- Range
- 10 Hz to 44.1 kHz, or half the sample rate, if that is lower
- Step
- 15 kHz
- Default
- 10 Hz
A control node can move it.
Connections
- Input
Sound comes in here, from one cable.
- Output
Sound goes out here, to any number of inputs.